roofRidge operation

Syntax

• roofRidge(valueType, value)

Parameters

1. valueType—selector
   { byAngle | byHeight }—Type of roof generation.
2. value—float
   Angle or height of the roof-planes as specified by valueType.

Description

The roofRidge operation builds a roof perpendicular to each face of the current shape's geometry. In contrast to the roofHip operation and the roofGable operation only one ridge is constructed. On arbitrary shapes no hips or gables are created but the shape outline becomes part of two angled roof planes.

The ridge is oriented wrt. the x-axis of the scope. Namely, the resulting ridge is parallel to the scope's x-axis projected to the face plane. To orient the ridge align the scope using operations like alignScopeToGeometry, alignScopeToGeometryBBox or rotateScope.

Note:

The connectivity of the roof mesh is optimized for trim plane generation to cut bricks inserted into the roof planes (see examples below).

Scope

The scope orientation is set in the following way:

• x-axis direction is kept as much as possible (old x-axis is projected to plane of the first face).
• y-axis along the face normal of the first face.
• z-axis normal to the two above.

The scope's sizes are adjusted to tightly fit the extruded geometry.

Related

• envelope operation
• extrude operation
• offset operation
• roofGable operation
• roofHip operation
• roofPyramid operation
• roofShed operation
• taper operation

Examples

Scope and trim planes

A roof with roof slope 30 degrees is built on top of an extruded lot. Note the setting of the pivot and scope. Lot --> extrude(10) Mass Mass --> comp(f) { top : Top | side = Sides. } Top --> roofRidge(byAngle, 30) Roof
After a component split, each roof face contains trim planes to cut bricks on insertion. Roof --> set(trim.horizontal, true) comp(f) { all : Face. } Note: Note that per default there are no horizontal trim planes at the ridges. To enable them, set(trim.horizontal, true) is used in front of the component split (details).

Ridge orientation

The scope is aligned to the top face using alignScopeToGeometryBBox with the xy selector. As a result the x-axis of the scope is the longer extent of the minimum area bounding rectangle. The resulting ridge is oriented "along" the shape. Lot --> extrude(10) Mass Mass --> comp(f) { top : Top | side = Sides. } Top --> alignScopeToGeometryBBox(xy) roofRidge(byAngle, 30)
Using a different selector yx will align the scope such that the scope x-axis is the shorter extent. The resulting ridge is oriented "across" the shape. Top --> alignScopeToGeometryBBox(yx) roofRidge(byAngle, 30)
The scope is rotated by 45 degress. The resulting ridge is oriented "diagonally" to the shape. Top --> alignScopeToGeometryBBox(xy) rotateScope(0, 0, 45) roofRidge(byAngle, 30)