reduceGeometry operation


  • reduceGeometry(tolerance)


  1. tolerance—float
    Controls the number of vertices which are going to be removed from the geometry. Valid values are in the range [0,1]. For instance, a value of 0.2 will reduce the vertex count of the geometry by 20%.


The reduceGeometry operation simplifies the geometry by applying a series of edge collapses.

This operation changes the appearance of the model. The algorithm tries to reduce the complexity of the mesh by introducing the least possible delta to the appearance of the existing model.


The operation removes all component tags from the geometry.



Reducing a terrain

The picture below shows a shaded terrain mesh. Left: the original (16384 vertices, 16129 faces). Right: after reduceGeometry(0.8) (3276 vertices, 5066 faces).

Terrain mesh before reduceGeometry
Terrain mesh after reduceGeometry

Terrain meshes

Closeup of the terrain meshes from the previous picture. Left original, right reduced.

Original geometry close up
Reduced geometry close up