Installing CityEngine

Complete the steps below to install CityEngine 2024.0.

Before installing CityEngine 2024.0

Before installing CityEngine 2024.0, do the following:

  1. Verify that your system meets all system requirements.
  2. This product requires authorization before use. To obtain authorization numbers, see Authorize the software.
  3. If you intend to use a concurrent-use license for this product, ArcGIS License Manager 2024.0 must also be installed. For more information, see ArcGIS License Manager for CityEngine quick start guide.
  4. Ensure that the user has administrator privileges.

Install CityEngine 2024.0

Complete the following steps to install CityEngine 2024.0:

  1. Start the CityEngine installation program, review the Introduction dialog box, and click Next.
    Note:

    If the CityEngine installation program does not start automatically, run the Setup script from the media or folder where the CityEngine installer was extracted.

  2. Review the license agreement, accept if you agree, and click Next.
  3. Click Next again to accept the default location, or click Choose and specify the installation folder.
    Note:

    It is recommended that you do not install CityEngine to a remote network drive. If the remote drive is not accessible when you are ready to uninstall, the uninstallation may fail and files may be lost.

  4. Review the summary information and click Install to begin the installation.
  5. When the installation is complete, click Done to exit the installer.
  6. After the License Manager service has been successfully configured, you can authorize CityEngine for use. For more information, see Authorize the software.