Back to Top

trim shape attribute

In this topic

    Syntax

    • bool trim.{horizontal | vertical}

    Description

    The trim attribute consists of a two booleans. It is used to control the application of trim planes to the current shape and its successors. Classification of the trim planes depends on the orientation of the edge which was used to define the trim plane (i.e. the shared edge between two pre-component split faces): if the angle to the xz-plane of the pivot is less than 40 degrees, the trim plane is horizontal, otherwise vertical.

    Classification of trim planes
    Classification of a trim plane depends on the angle between the ''generating'' edge (pink) and the xz plane of the pivot.

    Set the attribute to enable or disable the trim planes in horizontal or vertical direction.

    Note:

    Horizontal trim planes are disabled by default. To enable them, use set(trim.horizontal, true).

    Trim planes are created by a component split and applied using the insert operation, primitive operations, or the trim operation.

    Related

    • comp operation
    • i operation
    • set operation
    • trim operation
    • geometry.isInstanced function

    Examples

    Vertical trim planes

    Vertical trim planes are enabled by default. Trim planes are shown in green but not applied. 

    Roof--> 
    roofHip(45)
    comp(f) { all : Face. }
    		Vertical trim planes are enabled by default.

    Horizontal trim planes

    Horizontal trim planes are enabled by switching the trim plane attribute. Trim planes are shown in green but not applied. 

    Roof--> 
    roofHip(45)
    set(trim.horizontal, true)
    set(trim.vertical, false)
    comp(f) { all : Face. }
    		Horizontal trim planes are enabled by switching the trim plane attribute.

    Feedback on this topic?

    In this topic