Installing CityEngine

The steps below will guide you through the CityEngine 2020.0 installation process.

Before installing CityEngine 2020.0

Before installing CityEngine 2020.0, it is recommended that you go through the list provided below.

  1. Verify that your system meets all system requirements.
  2. This product requires authorization before use. To obtain your authorization numbers, see Authorizing your software.
  3. If you intend to use a concurrent-use license for this product, you need to install ArcGIS License Manager with version 2020.0 or newer (if it doesn't already exists for your use). For more information, see ArcGIS License Manager for CityEngine quick start guide.
  4. Make sure the user has administrator privileges.

You are now ready to proceed with the CityEngine installation.

How to install CityEngine 2020.0

Follow these steps to install CityEngine 2020.0.

  1. Start the CityEngine installation program and evaluate the Introduction dialog box. Click Next when you are ready to proceed.
    Note:

    If the CityEngine installation program did not start automatically, launch the Setup script from the media or folder where CityEngine installer was extracted.

  2. Review the license agreement and accept if you agree. Click Next to continue with the installation.
  3. Click Next to accept the default location, or click Choose to specify the installation folder.
    Note:

    It is recommended that you do not install the CityEngine to a remote network drive. If the remote drive is not accessible at uninstallation time, the uninstallation could fail and leave files behind.

  4. Review the summary information and click Install to begin the installation.
  5. At the end of an installation, click Done to quit the installer.
  6. After the License Manager service has been successfully configured, you are now able to authorize CityEngine for use. For more information, see Authorizing your software.