Skip To Content

Enable locations for your data

If your dataset does not contain a location field Location field, you can enable location with these location types: coordinates, addresses, or geographies. After you enable location, a new location field is added to your dataset. With a location field, you can create maps and perform spatial analysis with your data.

Enable location for your dataset

  1. From the data pane, click the Dataset options button Dataset options.
  2. Click Enable Location.
  3. Choose a Location type.

    Coordinates

    Make selections for the following parameters:

    • A field from the X (Longitude) and Y (Latitude) lists
    • A different spatial reference if desired

    Address

    Make selections for the following parameters:

    • A Geocoding service if there's more than one.
    • A Country for the address.
    • Under Address fields, choose One if the location description is in one field. Choose Multiple if the location description is separated across multiple fields.
    • Match the fields that correspond to the address field or fields in your dataset.

    Geography

    By default, one Location field is chosen, along with a Matching geography level. The estimated match accuracy between the fields is indicated with a sliding scale that ranges between No match and Best.

    You can do one of the following:

    • Choose a different Location field.
    • Choose a different Matching geography level.
      Note:

      Values in Matching geography level are pulled from standard or custom boundary layers in the data pane. If no geography levels are listed, you must add data that contains a location field Location field, such as a boundary layer or a feature layer.

    • Click Multiple to apply the same geography level to multiple fields.
  4. Click Run.
  5. A new location field Location field is added to the dataset.

About location types

Coordinates

Use the Coordinates location type if your dataset contains X,Y coordinates. Insights for ArcGIS can usually detect the X (longitude) and Y (latitude) fields in your dataset. You can override the suggested fields, and specify other fields.

For example, if your data contains two sets of coordinates, you might want to specify which coordinates you want to add location to. The default spatial reference is World Geodetic System (WGS) 1984 (4326). You can specify a different spatial reference. If you are unsure of which coordinate system to use, check with the person who created the spreadsheet or collected the data.

If your latitude (Y) values fall between -90 and 90 and the longitude (X) values fall between -180 and 180, use WGS84. If your latitude and longitude values are in meters and have 6, 7, or 8 digits before (to the left of) the decimal point, use Web Mercator.

Address

Note:

You must have the Geocoding privilege to enable locations by address.

ArcGIS World Geocoding Service can be used to enable location in your data by address. Credits will be used to enable location with ArcGIS World Geocoding Service.

Use the Address location type to enable location using the following:

  • One field when location descriptions are contained in a single field. Example:

    StreetAddress

    200 Brady St., Sudbury

    Each row in the above column generates a single point feature. You can choose a less descriptive field, such as PostalCode if you want to see each postal code as a point on a map. For area features, it's best practice to use the Geography location type (below).

  • Multiple fields when address information is separated across multiple fields. Example:

    StreetNumberStreetNameCity

    200

    Brady St.

    Sudbury

    Each row across the selected fields generates a single point feature.

Geography

Use the Geography location type to enable location for area features, such as a postal code boundary layer from Boundaries in the Add To Page window (see Add data from ArcGIS Online) or custom boundaries from other datasets on your page, such as police districts.

When you use the Geography location type, a join is performed behind the scenes between the current dataset and a custom or standard boundary layer from the data pane that you specify.